"Chapucillas" Ändern Gasregulierers

[johnny]

CHANGE OF GAS REGULATOR

In this "Chapucilla" we will show how changing a gas regulator, easy operation and requires the use of very few tools, in addition to other regulatory spare, with a wrench, a screwdriver and a knife is sufficient .
First we proceed to close the command of the gas, then a little loose nut fixing regulator, remember that the nut to loosen turn right (as usual), then loose with the screwdriver and pulled back the clamp metal squeeze tube orange.
We must check the expiry date of the orange tube, which is the expiration printed on the surface with more data, we now turn orange tube in his union with the regulator that turns freely, throw it out, once out of the regulator, with the help of a knife, remove the pipe end, which we see is tainted by pressure from the clamp.
We take the new regulator, which stayed in the previous post, after squeezing his nut conveniently fixation (turn left to squeeze), then proceed to introduce the free end of the regulator inside the tube orange, turning the hose on both sides until fully penetrate, move the metal clamp halfway around the end of the regulator and tighten the clamp properly, and now proceed to turn the knob opening the gas, we can put liquid soap on both ends or joints regulator and check that there are no bubbles, these will occur due to gas leak and that will squeeze more union where these occur.

This topic and many others can view it at:
http://chapucillas.acmur.es/