"Chapucillas" Tarima Toiletten

[johnny]

TARIMA TOILET

In this "Chapucilla" how we will try to avoid or delay a problem that is often given in our ACS (MH), which is none other than the appearance of cracks in the material covering the floor of our bathroom.

The emergence of these is because the existing material under the plastic floor of our toilets and the rest of the stage floor of our ACS, for whatever reason, this has transferred, leaving a little hole in our bathroom floor, using for our part of the same floor that is cracked, cracks open the above occur in the material.

To avoid reaching this point, once we notice that the floor of our bathroom is a bit hollow, what is being done is to place a plate on the floor, so that way when he stepped on the inside of our toilet, not to a load in a specific place, but on another surface interposed between them, which is responsible for distributing it more evenly and equitably as possible across the surface of the floor of our bathroom, we produce the load when he stepped on it.

To achieve this, we will place a plate cutting conveniently expanded polystyrene Chovafoam 125 x 60 x 3 cm., Which had in "Leroy Merlin" at a price of € 4'95.

To trim the plate, it must first make a mold to measure a board, which cut demand as we go the way of our bathroom floor, having to leave a gap around the perimeter of 0.5 cm., A 1 cm., slack when it needed to put the cuts or Polystyrene, these are not too tight preventing the proper drainage of water in case of showers.

Then these molds cardboard overlaid on the polystyrene plate and mark using a marker, then cut it with the help of a Calador later lijaremos edges to prevent in any way can damage the sides of the floor our toilet.

For normal use of our toilet, put on the cuts Polystyrene, rugs in our previous Chapucillas.


All this and many more items you'll see them at:
http://chapucillas.acmur.es/